Google Translate
FREE UK Delivery. Secure Credit Card Guest Checkout through PayPal.

Solenoid valve Electrical Connector Form A with 11-89% Energy Saving

Solenoid valve Electrical Connector Form A with 11-89% Energy Saving
Solenoid valve Electrical Connector Form A with 11-89% Energy Saving Solenoid valve Electrical Connector Form A with 11-89% Energy Saving Solenoid valve Electrical Connector Form A with 11-89% Energy Saving Solenoid valve Electrical Connector Form A with 11-89% Energy Saving
Brand: Nass Magnet GmbH
Product Code: DIN2-PWM
Availability: 82
Data Sheet  

Price: (inc VAT) £25.58 £17.14
Ex Tax: £14.28
Qty:     - OR -   Add to Wish List
Add to Compare

Form A DIN43650A PWM 11% to 89% energy saving electrical DIN connector with pulse width modulating circuit provides energy savings and extends the life expectancy of the solenoid valve or coaxial valve coil. The PWM connector receives a nominal voltage 12 volt to 48 volt DC in order to fully energise the valve solenoid allowing the solenoid valve coil to achieve the full inrush current and energy required to change the solenoid valve state. Then after a timed period of approximately 100 milliseconds the PWM circuit reduces the full voltage to a reliable holding power which needs to be adjusted to the holding power criteria of the solenoid valve coil thus achieving considerable energy saving and reducing coil heat rise which in turn extends solenoid coil life.
The power reduction is accomplished through pulses with adjustable modulation via relocation of the electrical jumpers for changes in the output voltage.
Operating voltage: Vdc = 24vDC, Maximum current = 1 Amp, Delay = ca. 175 ms, Switching Frequency = 3.1 Khz at 24vDC, Pulse - Pulse Ratio of PWM signal = 8 variations, Polarity sensitive = Yes, Over Voltage protection = No.
For optimum performance the solenoid coil technical data and electrical parameters must be observed. The PWM circuit includes a protecting diode at the output, eliminating the switch off power surges from the solenoid coil. Additional protecting components such as VDR and TVS diodes are not required. Article Number: 611-201-1042, New Ident Number 611-201-0100, forma ID 63010128
Quick Overview
Form: A (Pin Distance 18mm, with circuit with electronics – PWM, Housing: Transparent, One Piece M20x1.5mm Thread, Manufacturer: Nass Magnet
More Information
Grommets for 6–8 mm and 8–10 mm cable diameter, Terminal block: 2 + ground, clamping contact without protecting plate, Electronics: PWM circuit for power sawing, 12–48 V DC, NBR profile gasket, black, Standard central fixing screw, Not assembled and single packed in a plastic bag

Review product & our service

Your Name:


Your Review: Note: HTML is not translated!

Rate our service: Bad           Good

Enter the code in the box below:



Connexion Developments