Electrical Connector Form A with 20-65% Energy Saving IP65 12-24vDC

£35.03

£42.00 incl. VAT
£29.19 ex. VAT

Brand: Nass Magnet GmbH

Model: DIN2-PWM

Stock: 144 in stock

Read Full Description

Description

Form A EN 175301-803 12-24vDC Pulse Width Modulating 20% to 65% energy saving electrical DIN connector 611-201-1320.

PWM connector will fully energise the valve solenoid to achieve full inrush current. Then, after approximately 100 milliseconds, the PWM circuit reduces the full voltage to a reliable holding power that needs to be adjusted using the 2-1 jumpers to the holding power required by the solenoid valve coil.

This achieves considerable energy saving, reduces coil heat rise and extends solenoid coil life.

PWM modulating connector jumper settings for the Hold Power Saving
00..20%, 01..35%, 10..50%, 11..65%

Buy 50 pcs £24.88 each or 100pcs £14.94 each

Simplified guide to setting up.
With the pipe system at full load / pressure, reduce the power in single stages until the coil fails to operate correctly, then go back one step.
Example starting with (00) 20% reduction, then (01) 35%, (10) 50% and (11) 65%, then if coil stops holding so go back to (10) 50%.

The power reduction is accomplished through pulses with adjustable modulation via relocation of the electrical jumpers for changes in the output voltage. (default setting 20%)
Operating voltage: 12-24vDC
Maximum current: 2.5 Amp
Resistance: <15mOhm
Protection: diode
Delay = ca. 150 ms
Switching Frequency = 2 kHz at 24vDC,
Pulse Ratio of PWM signal = 4 variations,
Polarity sensitive = Yes
Overvoltage protection = No.

For optimum performance, the solenoid coil technical data and electrical parameters must be observed. The PWM circuit includes a protecting diode at the output, eliminating the switch off power surges from the solenoid coil.
Additional protecting components such as VDR and TVS diodes are not required.

Quick Overview
Form: A (Pin Distance 18mm, with circuit with electronics – PWM, Housing: Opaque (Milky), One Piece M20x1.5mm Thread, Manufacturer: Nass Magnet
More Information
Grommets for 6–8 mm, Terminal block: 2 + ground, clamping contact without protecting plate, Electronics: PWM circuit for power sawing, 12–24VDC, NBR profile gasket, black, Standard central fixing screw, Not assembled and single packed in a plastic bag.

Technical Specification

Brand: Nass Magnet GmbH

Model: DIN2-PWM

Width: 28.00 mm

Height: 31.00 mm

Depth: 28.00 mm

Weight: 0.05 kg

Voltage: 12vDC, 24vDC

Approvals: IP65

Spare Parts: DIN connector Form A